Buck Rogers K4ABT Návod k obsluze stáhnout pdf (Strana 44)

The Packet Radio “2 N 1” Handbook by Buck Rogers K4ABT

Section 1; Packet Radio “The Basics” Section 2; The X1J4 System Node Operator’s (SNO) Handbook

Section II; TheNET X1J4 System Node Operators Handbook __ Page 44

Chapter 18 Section II

The SEVENTEEN X1J4+ MODE COMMANDS AND DEFINITIONS

With the new X1-J version of theNET firmware, there also comes a set of 17 added command features. The

application of these 17 features can increase the effectiveness of your network when they are properly applied.

SEDAN MIN MAX DEFINITION

0 0 1 Host Control to enable HARDWARE HANDSHAKE; MODE FLAG in HOST MODE

Enables the use of the Esc C and Esc D commands when using the RS-232 port.

0 0 3600 CW ID repeat period in seconds.

0 Disables CW ID

6 4 10 CW ID speed (10 milliseconds per DOT)

3 0 3 Nodes broadcast enable flags: 0=None, 1=HDLC only, 2=RS-232 only, 3=Both ports.

3 = both ports if backbone access; 2=matrix; 1 if LAN or user port.

0 0 3 Crosslink select: 0=None, 1=HDLC, 2=KISS,+selectCopy, 3=KISS+ALLcopy

MATRIX mode for node stack use.

35 0 255 TX keyup delay (TXDELAY) in ten millisecond increments. 35 = 350 milliseconds; for

most transceivers, add 5 mSec for radios with relays nodes using external power amplifier.

0 0 1 Full Duplex enable. 0 if node is operated in simplex (normal) operation.

500 0 65535 RS-232, PORT 1, node broadcast period in seconds. 600 Updates nodes every 10 minutes.

0 0 3 Node broadcast algorithm flag; 0=off, 2=RS-232 port; 1 or 3 not used.

600 600 3600 Beacon interval in seconds.

600 Although beacons are enabled in PARAMS to ID only during or after use.

1 0 2 Connect redirect to BBS

0 Controls the use/action of the "C" command, and what it will do when issued.

27 0 127 Help messages enable flag, 8 bit in TALK mode & case sensitive. 19 Enables:

PLEASE WAIT. (1) + all sysop commands, (2) +Routes are: ALIAS:CALLSIGN

0 0 3 Hash node broadcast disable (1 bit per port) 3 will disable all #node broadcasting.

0 0 1 If set, will enable extra alias monitoring. 0=WILL NOT recognize BBSalias, DXalias,

HOSTalias, set to 1 on user port if BBSalias is set.

1 0 1 Enables automatic node reconnection after remote disconnect.

1 Enable on user accessed ports and #nodes; Disable on network step points (BBS..etc).

0 0 3 Slime trail control. Each bit controls a function; Bit 0 hides; Bit 1 causes slime to be ignored.

3 Set on non gateway port(s).

3 0 3 Digipeat control. Each Bit controls a function: Bit 0 Node refuses L2 uplink digis.

Bit 1 Node refuses digi downlinks.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 66 67

Žádné komentáře

Buck Rogers K4ABT Návod k obsluze Strana 44